The Cart Before the Horse: Spec 3 Build

[Senor_Taylor]

Took a break from the e21 and did some stuff to the Fiesta which then let me make more space in the garage so I could work on the engine again. Finished disassembling down to the block and crank. Exhaust cam bearing surfaces did not look good. Intake cam looked fine, but then that intake valve that dropped did not look good at all.

Got the other engine off the truck and into the garage. Taking a break for now after a full day in the garage and I'll pick back up tomorrow after tending to the F150. Need to swap the water pump, oil pickup, oil pump nut and safety wire (ordered new), exhaust manifolds, engine mounts, fuel rails, install new oil pan gasket and valve cover gasket, remove ac compressor and bracket/pulley, swap over coolant block off plate from head and coolant temp sensor. Inspect sensors and wires, install new rear main seal, flywheel, clutch, then bolt up the trans and throw it back in.

Sent from my Pixel 4a using Tapatalk