The Cart Before the Horse: Spec 3 Build

[Senor_Taylor]

Throwout bearing and pivot pin were pretty much dead. Replaced those, new clutch arm sprint as well. Got the rear main seal housing replaced with new seal, and fought the pilot bearing for like 30 minutes with a slide hammer that was too small, so I switched to the wet toilet paper method which was slow, but effective. New pilot bearing in, cleaned the flywheel and clutch and got those on (thank Tyler for holding the motor so I could torque them!) Then got my cheap clutch alignment tool stuck. Taking a break and sleeping on it before I put the trans back on in case I forgot something or messed something up.

Sent from my Pixel 3 XL using Tapatalk