Project: AWD Turbo Family Hauler (PART DEUX)

[JustinG]

Intake came in early.

Making wooshy noises now.

OEM air box


What's in the box?!?!?!?!?





30 min later



Not crazy loud, but noticeable turbo noises, more spool and bov.

I can only imagine if I replaced the turbo inlet with a hard pipe vs the plastic/accordion oem inlet.

Also got this today....



It's installed via 2 connectors, MAP and TMAP.

I had to move it from where it is in this pic. The cowl cover wouldn't latch completely. Apparently the box is not 100% water proof, so I put it in a ziploc freezer bag, taped it up real good and tucked it next to the brake master on the the fender side. They sell waterproof cases for the circuit board, may look into one.



Haven't loaded a map yet as I was waiting to be sure the firmware is up to date. It is running fine in bypass, so the JB4 is technically off, but allowing the sensor signals I plugged into to pass through and work normally.

Confirming the firmware is up to date tomorrow, and will give Map 1 a try, 4psi over stock.