2013 BMW 135is

[ryangreen1]

nice fix - is it worth running a bead of silicone sealant around any gaps where the ballast plugs in to prevent future condensation, or would that cause ballast cooling issues?

There is a rubber seal around where the ballast plugs in that looked fine but there was water around it. I was thinking of running some sealant both there and along the headlight cover where it seals too.

I also need to figure out how to get the condensation out of the bad headlight. I got a blow dryer that worked ok but it fogged right back up the next day when it rained so apparently it’s still not a good seal


Sent from my iPhone using Tapatalk