06-01-2017, 11:23 AM
Sum it up, called FM. Tami was nice and friendly. Got forwarded to Eric. He will have everything taken care of if new part(s) needed.
He said the threads are reverse on two end links (no instructions, so I didn't even think about it). So I'll try again tonight I and see if anything changes. He said to not force on the nuts or connecting pieces become angled again when trying to thread (that's why I stopped last night). So, tonight I'll retry again with spinning different directions. I tried similar things last night but I stopped to make sure I wasn't going to cross thread anything since they were angling weird. The classic probable user error and why I didn't want to slam a vendor
. Hopefully all goes well or the sway bar will be disconnected until sometime next week when extra part arrives. Problem solved.
He said the threads are reverse on two end links (no instructions, so I didn't even think about it). So I'll try again tonight I and see if anything changes. He said to not force on the nuts or connecting pieces become angled again when trying to thread (that's why I stopped last night). So, tonight I'll retry again with spinning different directions. I tried similar things last night but I stopped to make sure I wasn't going to cross thread anything since they were angling weird. The classic probable user error and why I didn't want to slam a vendor
. Hopefully all goes well or the sway bar will be disconnected until sometime next week when extra part arrives. Problem solved.