electrical question

[white_2kgt]

yes, continuity just means that an electrical current is passing though. You need to make sure the fuse that is install is of the correct amperage. If its blowing 15amps don't just put in a 20amp fuse, that will burn up your wires. If you are worried that the blubs are drawing to much current use a multimeter and check the current draw across the circuit. If it's drawing more than the system was designed to handle just install a relay, they are cheap and can be picked up at ratshack/auto store for a few bucks. moving circuits around can help but only if it doesn't draw more than the designed current.

good luck,
--chad