+- Madison Motorsports (https://forum.mmsports.org)
+-- Forum: Technical (https://forum.mmsports.org/forumdisplay.php?fid=4)
+--- Forum: Technical Discussion (https://forum.mmsports.org/forumdisplay.php?fid=11)
+--- Thread: Corner balancing (/showthread.php?tid=7229)
Pages:
1
2
- Evan - 04-23-2008
Ole Wrote:yes!!!!?!!????!Evan Wrote:Bret at RP charged me $250 to install new tophats, align, and cornerbalance my pile.
tell him Evan referred you
You put 99 hats on your car????
along with the spacers.
although the car wasnt lowered to compensate so I think all it did was give more room for body lean!
![[Image: 281112239_mtQVZ-L.jpg]](http://evan55.smugmug.com/photos/281112239_mtQVZ-L.jpg)
- Ole - 04-23-2008
Quit showing those few shots of you in front of me! :finger:
- Maengelito - 04-24-2008
you could always just post up pics of his dented fender.
speaking of which, evan did you find out if there was more than just cosmetic damage?
- Evan - 04-24-2008
Maengelito Wrote:you could always just post up pics of his dented fender.
speaking of which, evan did you find out if there was more than just cosmetic damage?
There isnt any visible suspension damage, but I checked the alignment and its 1/4" toed out and more neg camber. So I think Ill just reset the toe and go.
The fender damage has popped out surprisingly well. The worst looking part of it now isnt from the impact, its from where my teammate banged it with a hammer :roll: :wink:
- Maengelito - 04-24-2008
did you end up doing the craftsman digital level camber gauge? if so, I'd be interested in a step-by-step if you're willing to write one.
- Ole - 04-24-2008
Evan Wrote:Maengelito Wrote:The worst looking part of it now isnt from the impact, its from where my teammate banged it with a hammer :roll: :wink:
What idiot did that? :oops: