11-14-2006, 07:48 PM
Before putting a drill anywhere near the engine I'd like to know why the rounded bolt tool didnt work - was there not enough room? Not enough bite?
If the head is still on the bolt its quite possibly going to be a bitch to pull out. You are much better off with a drill and an ez-out rather than just hogging out the hole and hoping you can re-tap it.
If the head is still on the bolt its quite possibly going to be a bitch to pull out. You are much better off with a drill and an ez-out rather than just hogging out the hole and hoping you can re-tap it.