02-27-2006, 02:39 PM
Mike Wrote:ew... i'm guessing it wouldn't cost that much for a more open car that they have done many times before?
They might save some time (and $$) but not much. Its all done by labor, so take it for what you will. What you can do is buy a wedge engineering or sparco seat base, and the sparco side mounts and bring them in and have them modified/reinforced/etc - this will save some time in fab and thats what I did. Seat mount bill at piper was around $250, including the universal slider ($40).
Hunter - I think there are better bolt in options for the BMW's.