07-10-2018, 11:07 PM
![[Image: 36904130_10156568044656810_8276990780753...e=5BA07645]](https://scontent.fric1-1.fna.fbcdn.net/v/t1.0-9/36904130_10156568044656810_8276990780753575936_o.jpg?_nc_cat=0&oh=6eabd4819c004216fc1e784e253e84e4&oe=5BA07645)
Didn't get into the garage until almost 9 but made some good progress once I got rolling. Just need to trim the passenger side a bit to get the collector back on and the exhaust should be good to go. Was going to mess with the radiator a bit but realized I have the car up too high at the moment to use my prop rods without the hood hitting the beam it's under. So that'll have to wait until the exhaust is complete and the car is back on the ground.
Only part I'm worried about is my little adapter for the upper hose got destroyed yet again. It's a thin little sleeve that reduces the 1.625" adapter to 1.5". I'm hoping I can just get away with cranking down on the hose clamps since it seems to be too tight of a fit anyways. If that doesn't work I'll probably try a thin layer of silicon. If that doesn't work I'll probably try setting the car on fire and pushing it off the overlook at the top of Massanutten.