Project: R3D3MPTION?

[D_Eclipse9916]

Tested a couple panels with some compound I had. This should actually clean up nicely aside from the rust spots.





Put back together the interior that was apart, installed headlights and headlight trim. Waiting on the fan, a couple clips from the dealer, and an exhaust gasket.

Still to do:
E36 exhaust doesnt fit as is. Cutting midpipe and rotating, adding some mounts and cutting the body a bit for the dual pipe exit.
Adding E30 Brown Coolant Temp Sensor as adapter harness does not work with stock E36 coolant temp sensor
Cut and fit wiring panel covers
Find fan temp sensor that works with stock wiring or find pigtail that will plug into E36 sensor and wire that in
Wire in Fan to stock wiring
Mount hood/bumper/trim
Bend Bracket for throttle cable as it is at end of adjustment and would like it to be in middle
Fab bracket for Dipstick holder
Final nut/bolt
Bolt up wheels being delivered by Dave this Friday
Italian tune up


If I get time:
Fab bracket for Diagnostic Port
Put car on scales
Million little things...