Project 2.Slow Mazda3

[D_Eclipse9916]

Can get a torch kit at Lowes for like 20 bucks

Gets hot enough for exhaust manifold temperature? I want to make sure these threads are burning up and add some PB to them and then smack them with a hammer. Hoping that will do it...

Edit: I think I'll pick up a decent vice not from Harbor Freight and that torch and give it a try again... probably end up lighting it on fire instead though.

:lol: Been there done that. If its off the car you can always come up with a wrench about the size of the 02 sensor and I can weld the wrench to the 02 and get it off (the heat from the welder also helps pop it out).