Project: R3D3MPTION?

[D_Eclipse9916]

Progress is going a bit slower than I had hoped this weekend. I ended up spending 99% of my "garage time" this weekend organizing, hanging more shelves and setting up my new toolbox.

I did make some progress, but also discovered some more stuff that should be replaced. (or tell me to STFU). It was a rough day
Rear shocks are completely blown. They have 0 rebound.

Shock tower mounts are blown as well, (clunk clunk clunk)
https://www.facebook.com/7816010/videos/...862150419/
Rusty Brake Lines
Tweaked Radiator (sorry that baller radiator is completely tweaked from the accident, might wan t to see if Bimmerworld has any exchange program? I did find a radiator to use though for $50)
Missing radiator support


Need 2 more hard brake lines that run along the trailing arm, they are rusty too. Thank god you decided to do the main line. I soaked the ones we weren't replacing in penetrating oil but as soon as I hit them with a wrench...an inch down the line it cracked in half. The lines wouldn't have lasted that much longer if we had ignored them.





Trailing arm bushings aren't looking so hot either, but up to you.


I am also missing the idle control valve and associated rubber hoses. Matt do you mind taking a look around to see what you have? Also there are plastic pieces that hold up the radiator in the car. One is missing from the passenger side, maybe Jake Lind has a spare?


Good progress made?

Front brake lines replaced
Wiring harness is in car and mostly assembled. (do you have the stock "wiring cover" that comes with an E30? Also do you have a stock E30 Center Support Bearing for driveshaft?)
Replaced the cut fuel lines and routed them where they need to go
Finished power steering and filled with fluids
Moved the shifter support, for some reason it was bolted in a lower hole and not mounted at the top making the shifter contact the drive shaft. (m20 thing maybe)