03-22-2016, 10:00 AM
Things I'll need to buy for the job: silicone, spray paint, center punch, and drill bit set with at least a 7/16" and smaller (also need to see the size of the roll bar bolts).
Jake, I've been looking at correct mounting online. I don't think we will have issue with the tunnel belts (sub) as they just may be a little uneven in height. There is empty space under the seat on the inside of the seat bracket. The outside lap belts may have an issue with rubbing. We'll just have to see. There are no write-ups on this for my car so I'm going to try to do a short one with a few pictures.
Is anyone free the weekend before Hyperfest? That would be the 14th of May.
Edit: Kaan said he is willing to let me borrow drill bits and to check to see if DJ has any to spare?
Jake, I've been looking at correct mounting online. I don't think we will have issue with the tunnel belts (sub) as they just may be a little uneven in height. There is empty space under the seat on the inside of the seat bracket. The outside lap belts may have an issue with rubbing. We'll just have to see. There are no write-ups on this for my car so I'm going to try to do a short one with a few pictures.
Is anyone free the weekend before Hyperfest? That would be the 14th of May.
Edit: Kaan said he is willing to let me borrow drill bits and to check to see if DJ has any to spare?