03-31-2015, 06:56 AM
I tacted in the new metal. 18ga to match the thickness of the seam and the metal rear of that. the pan is 20ga maybe
![[Image: Tacted%20In_zpsm1ig9ron.jpg]](http://i883.photobucket.com/albums/ac32/JMURACN/Tacted%20In_zpsm1ig9ron.jpg)
I took it slow, moved the heat around, ground down the thin metal side to make sure I didn't over heat it. 1st coat of sealer
![[Image: 1st%20Coat_zpsiypprgdu.jpg]](http://i883.photobucket.com/albums/ac32/JMURACN/1st%20Coat_zpsiypprgdu.jpg)
![[Image: Tacted%20In_zpsm1ig9ron.jpg]](http://s883.photobucket.com/user/JMURACN/media/Tacted%20In_zpsm1ig9ron.jpg.html)
I took it slow, moved the heat around, ground down the thin metal side to make sure I didn't over heat it. 1st coat of sealer
![[Image: 1st%20Coat_zpsiypprgdu.jpg]](http://s883.photobucket.com/user/JMURACN/media/1st%20Coat_zpsiypprgdu.jpg.html)
#99 - 2000 Civic Si (Future H2 Car, Former H1 car)
IPGparts.com, AutoFair Honda, Amsoil, QuikLatch Fasteners
NASA-MA Tech Inspector (Retired)
IPGparts.com, AutoFair Honda, Amsoil, QuikLatch Fasteners
NASA-MA Tech Inspector (Retired)