Project 6.0L Sedan

[D_Eclipse9916]

^^ Dave yup, but makes it a pain to move around. At least with the LS1 it doesnt seem to be a problem, BMW engines/most 4-cylinders you definitely cannot. Maybe I am wrong
First of all, I won this ebay auction. It has ebay buyer protection, I searched forever trying to find if the guy was a scammer, and finallly...paid through paypal and used a credit card. This auction comes with EVERYTHING else I needed for the swap (aside from small ancilarries like hoses, and mods like cams/intake). Cheaper than anythiing else I could find by a large margin.


I was in town this weekend for memorial day and had my family over, so there wasnt much free time; but I did get a little clean up done on the LS1s.
First of all, pulled all the stuff I would need from my donor LS1 to the LS1 that I would be using such as knock sensors, Cam/Crank/Oil pressure sensors, and a few brackets. Threw those on the LS1 I would be using. I also pulled off the wiring harness and labeled each connector.

Pulling out the motors to middle of the garage, this stand is awesome!


Tore down and put in the corner the LS1 to be sold


LS1 Intake Manifold for sale as well



Installed sensors and some of the brackets onto LS1 that I will be using.


Tagging and labelling the Wiring Harness