10-31-2011, 12:36 PM
Looks like I am finally going to swap the extended studs onto the front of my car this week. Rears were simple and done in about 15 minutes per side. Pull the drum open, take off the spindle nut, remove piece that holds studs (spindle?), pound studs out, pop new ones in, tighten stud with washer and socket combo until it was seated. However, the fronts require the hubs to come apart and bearings out. As Justin recommended, I will probably replace the wheel bearings at the same time. Can anyone recommend a decent place in Harrisonburg to get the new bearings pressed in? Or does anyone local have a press and be willing to do this?
2019 Accord Sport 2.0 A/T
2012 Civic Si - Sold
2012 Civic Si - Sold