03-30-2010, 04:03 PM
Very soon in the next couple of weeks ill be putting in the roll bar, seats, and harnesses that I have for the bimmer, and was wondering if anyone had any good links or knew how to properly mount harnesses.
I need specifics, im not dumb and have a decent amount of mechanical knowledge so I know im doing eyelets with a 4x4 backing plate for the lap and sub belts, I knwo the correct mounting diagrams for doing the shoulder belts, but I would like someone with experience to help me with finding a good place to drill for the lap and sub belts to make proper angle for safety in an E36. If not, ill just pay RRT to install the harnesses, id rather pay 100 bucks to get the angles right then just start drilling holes in my car.
And before anyone says it, no I will not just mount the harnesses to the seat bracket, im a person that likes it done right despite any "it did fine".
I need specifics, im not dumb and have a decent amount of mechanical knowledge so I know im doing eyelets with a 4x4 backing plate for the lap and sub belts, I knwo the correct mounting diagrams for doing the shoulder belts, but I would like someone with experience to help me with finding a good place to drill for the lap and sub belts to make proper angle for safety in an E36. If not, ill just pay RRT to install the harnesses, id rather pay 100 bucks to get the angles right then just start drilling holes in my car.
And before anyone says it, no I will not just mount the harnesses to the seat bracket, im a person that likes it done right despite any "it did fine".
2020 Ford Raptor
2009 Z06
1986.5 Porsche 928S
2009 Z06
1986.5 Porsche 928S