12-19-2009, 12:03 AM
Long time, no update. Few projects I've been working on recently outlined below:
Finished up the floor pans and such by seam sealing and finishing painting the interior, then priming and putting rubberized undercoat on the bottom of the car. Interior will be completely done after guages are put into the dash (after I buy them) and it's reinstalled.
![[Image: Belly%20Coated.JPG]](http://93anthracite.com/240z/pics/Belly%20Coated.JPG)
Pulled the engine and transmission:
![[Image: EngineBay%201.JPG]](http://93anthracite.com/240z/pics/EngineBay%201.JPG)
Then removed the sheet metal around the engine bay:
![[Image: EngineBay%202.JPG]](http://93anthracite.com/240z/pics/EngineBay%202.JPG)
Was planning on just replacing all the fuel and hydraulic hard lines, but I'm going to strip the engine bay and clean it up since the engine is already out and that should be a relatively low-budget task. I've pulled everything out, time to remove all the old paint, prime, and make it look good again.
![[Image: EngineBay%204.JPG]](http://93anthracite.com/240z/pics/EngineBay%204.JPG)
![[Image: EngineBay%207.JPG]](http://93anthracite.com/240z/pics/EngineBay%207.JPG)
Finished up the floor pans and such by seam sealing and finishing painting the interior, then priming and putting rubberized undercoat on the bottom of the car. Interior will be completely done after guages are put into the dash (after I buy them) and it's reinstalled.
Pulled the engine and transmission:
Then removed the sheet metal around the engine bay:
Was planning on just replacing all the fuel and hydraulic hard lines, but I'm going to strip the engine bay and clean it up since the engine is already out and that should be a relatively low-budget task. I've pulled everything out, time to remove all the old paint, prime, and make it look good again.