04-22-2009, 12:27 AM
Update:
A couple weeks ago, Pete and I cut out the old floor pans and welded in some new ones.
Last week, I had a local shop install my beefy frame rail replacements as well as a 1x1 square tube along the rockers that will serve as my jack point and place to put jack stands.
This past weekend I cleaned it all up and repainted the interior to get the rollbar and pans, as well as touch up a few areas that were scratched/marred during the other installs.
Here's some pictures of the current state, but if you want details or more pics go here:
![[Image: floorpan3.JPG]](http://93anthracite.com/240z/pics/floorpan3.JPG)
![[Image: floorpan5.JPG]](http://93anthracite.com/240z/pics/floorpan5.JPG)
![[Image: Quality%201.JPG]](http://93anthracite.com/240z/pics/Quality%201.JPG)
![[Image: ChasPaint2.JPG]](http://93anthracite.com/240z/pics/ChasPaint2.JPG)
![[Image: SeatsHarn2.JPG]](http://93anthracite.com/240z/pics/SeatsHarn2.JPG)
I'm actually going to be pulling the seats back out and putting down some seam sealant b/c I didn't have it until today. Then I can finish up the seat and harness install until I'm ready to put the dash back in.
A couple weeks ago, Pete and I cut out the old floor pans and welded in some new ones.
Last week, I had a local shop install my beefy frame rail replacements as well as a 1x1 square tube along the rockers that will serve as my jack point and place to put jack stands.
This past weekend I cleaned it all up and repainted the interior to get the rollbar and pans, as well as touch up a few areas that were scratched/marred during the other installs.
Here's some pictures of the current state, but if you want details or more pics go here:
I'm actually going to be pulling the seats back out and putting down some seam sealant b/c I didn't have it until today. Then I can finish up the seat and harness install until I'm ready to put the dash back in.