07-10-2008, 07:23 AM
Another quick question....
Long story short, the hardline leading to the fuel pump hanger kinked and bent upon attempted removal, a notorious MK3 problem. This meant I had to buy a new hanger, which I have.
The install guides I'm using have pictures like these (not mine) showing 2 hanger wires leading to 2 Walbro wires....black to black and blue (green after 20 yrs of gas) to red.
![[Image: DSC01987.jpg]](http://i126.photobucket.com/albums/p87/forcedtorque/DSC01987.jpg)
![[Image: DSC01991-1.jpg]](http://i126.photobucket.com/albums/p87/forcedtorque/DSC01991-1.jpg)
Now, my new hanger has this wire on the back that I, and so far others, can't explain, leading to a resistor. This leaves me with 3 hanger wires vs. 2 Walbro wires. What would such a thing do, and if others don't have/use it, can I just wrap the end in tape and forget about it?
![[Image: hangerbg3.jpg]](http://img88.imageshack.us/img88/6637/hangerbg3.jpg)
![[Image: wiresgn3.jpg]](http://img80.imageshack.us/img80/4213/wiresgn3.jpg)
Long story short, the hardline leading to the fuel pump hanger kinked and bent upon attempted removal, a notorious MK3 problem. This meant I had to buy a new hanger, which I have.
The install guides I'm using have pictures like these (not mine) showing 2 hanger wires leading to 2 Walbro wires....black to black and blue (green after 20 yrs of gas) to red.
Now, my new hanger has this wire on the back that I, and so far others, can't explain, leading to a resistor. This leaves me with 3 hanger wires vs. 2 Walbro wires. What would such a thing do, and if others don't have/use it, can I just wrap the end in tape and forget about it?
Current: '20 Kia Stinger GT2 RWD | '20 Yamaha R3 | '04 Lexus IS300 SD
Past: '94 Mazda RX-7 | '04 Lexus IS300 (RIP) | '00 Jeep XJ | '99 Mazda 10AE Miata | '88 Toyota Supra Turbo
My MM Movies - Watch Them Here
Past: '94 Mazda RX-7 | '04 Lexus IS300 (RIP) | '00 Jeep XJ | '99 Mazda 10AE Miata | '88 Toyota Supra Turbo
My MM Movies - Watch Them Here