03-09-2007, 07:02 PM
Sounds good, see you all then. I've been fiddling with my car after work this whole week getting ready, new power steering lines last night and fixed a coolant leak the day before. I cut my old steering lines off since they had stupid permanent fittings on each end, 300psi flame resistant hose went in it's place.
Oh, also is anyone going to bring a jack, or should I bring mine? I have a low profile aluminum craftsman one that works on most lowered cars. I'll bring a torque wrench, the click kind. Does anyone have an air tank or a electric compressor? What about tools? My friend is bringing his decent set of metric sockets and hand tools. I think every size from 7-19mm in hand and sockets, 3/8" drive. Perhaps we could divide some of this stuff up so we all don't have to bring it all. Maybe I'm over-preparing?
-Peter
Oh, also is anyone going to bring a jack, or should I bring mine? I have a low profile aluminum craftsman one that works on most lowered cars. I'll bring a torque wrench, the click kind. Does anyone have an air tank or a electric compressor? What about tools? My friend is bringing his decent set of metric sockets and hand tools. I think every size from 7-19mm in hand and sockets, 3/8" drive. Perhaps we could divide some of this stuff up so we all don't have to bring it all. Maybe I'm over-preparing?
-Peter
Current:
- 1993 325is Black/Black 97 STX Christine
-2015 Ford Fiesta ST OW Ms Fiesty
Past:
-2002 Ford Ranger 4.0 XL 5MT AKA Goldy Locks
- 1993 325is Black/Black 97 STX Christine
-2015 Ford Fiesta ST OW Ms Fiesty
Past:
-2002 Ford Ranger 4.0 XL 5MT AKA Goldy Locks