01-15-2007, 10:49 PM
I need what is essentially a thick washer. It has to be 3.5 OD/2.5in ID.
Like this one:
![[Image: DSC04013_big.jpg]](http://www.we-todd-did-racing.com/files/980411_n2rdf/DSC04013_big.jpg)
I'm going to weld it on to my spare strut shells for my coilover project and serve as the lower perch that will hold up the sleeves.
Also, will any coilover sleeves do? Has anyone seen any failures of less expensive units. I'd hate to blow 400 bucks on a set of GC's if I don't have to.
My other option is this:
![[Image: GCkit-26sml.jpg]](http://www.we-todd-did-racing.com/files/980414_hwbju/GCkit-26sml.jpg)
Trim the stock spring perch back but keep enough to hold the sleeve in place. Thoughts?
Like this one:
I'm going to weld it on to my spare strut shells for my coilover project and serve as the lower perch that will hold up the sleeves.
Also, will any coilover sleeves do? Has anyone seen any failures of less expensive units. I'd hate to blow 400 bucks on a set of GC's if I don't have to.
My other option is this:
Trim the stock spring perch back but keep enough to hold the sleeve in place. Thoughts?
Two feet.